what is Gas welding ?

oxyacetylene gas welding is commonly used to permanently join mild steel a mixture of Oxygen and
acetylene once as an intense focus today at approximately 3500 degrees send when the flame  comes
in contact with it melt the surface forming a Melton hole allowing welding to take place oxyacetylene can
also be used racing bronze welding forging shaping welding and cutting this type of welding suitable for
the perfect location of Steel sheet tubes and plates.

Slowly open the main wall of the tank and adjust clean pressure regulator to 5 Pounds per square
inch open the needle valve on the torch and adjust the pressure on  the regulators to show 5 pound
close the needle valve go through the same procedure for oxygen cylinder.

filler material are used to simply additional material the  world ozone flax is often used to clean the
surface and to restart oxidation by providing inert gas Shield Around .

The World area in removing oxide and their impurities borax is the most common flux but sometimes.
The Other substance are added to improve the effectiveness of the heat is obtained by the combination
of acetylene and oxygen temperature at the tip of inner join richest up to 3000 to 3500 therefore most gas
welded is performed by keeping this inner zone it just above the metal to be welded so that maximum them
available for welding.